NAVIS NavDP 4000. Operation Manual
(a) Active Track
(b) Offset Track
Figure 10.47: Map Window
10.7
Autopilot Function
NOTE!
Autopilot (AP) is not approved for navigation and cannot be used as
navigation equipment.
WARNING!
AP mode is intended for performing control from control stations
with forward orientation located on the navigation bridge.
It is not recommended to use this mode at the control stations
with aft orientation! In case AP mode is present and used from
the control station with aft orientation, the operator should set and
change heading with special care and attention!
Autopilot function is used for heading control of vessel at high speed.
In the Autopilot mode, the right part of the Operator Interface Screen is only used for displaying the Autopilot window
(see Figure 10.48). The left part can be used for displaying other windows.
Use the center part of Autopilot window to get steering system controls status (see Figure 10.49)
The bottom of the Autopilot window contains controls to change the Autopilot parameters (see figure 10.50)
There are compass rose at the top of the Autopilot window and some additional information.
The main part is half the compass rose, which is scaled in degrees. On the inner arc digit designation of heading are
shown. On the outer arc scale with divisions at 5 degrees are shown, and also the common letter symbols are represented
(in circles) (see figure 10.51). Direction and speed of vessel rotation are shown as
below the compass
rose scale. Units of rotation speed can be changed on PARAM window on Units tab (see 5.9, page 85).
The yellow triangle pointer and yellow digit bar are used for displaying the actual heading, while the green triangle
pointer and green digit bar are used for displaying the heading setpoint. The white digit indicator displays a new value for
the heading setpoint.
Difference between the set and the actual heading is shown by the number in degrees on left or right (depending on
the direction of the deviation) of digit bar.
201
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
