NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 191 / 348

System Functions
Figure 10.29: Track Mode
– in DP mode: distance to the new track should be less than 100 m;
– in AP mode: distance to the new track should be less than 3 nm;
– in AP mode: difference between course desired by track and current course shouldn’t be more than 60 degrees;
– when external track was sent, system checks if vessel is on
LS Track
mode or no.
In positive case, new track is ignored and alarm is appeared;
– NAVIS NavDP 4000 system allows to choose tracking mode, parameters of that mode and active route only to-
gether. For example, track in dredging mode can be active and dredging mode can be run only if rules described
above are accomplished.
10.6.3 Track Window
The Track window (see Figure 10.30) is used to create, edit, delete, save to / and load from USB flash drive, load
external route by COM/Ethernet port and for monitoring the track following.
Press Select window softkey on the SYS panel for choosing the Track window .
The top section displays route list or the waypoint table (depending on selected mode).
It could be switched to the following modes:
RT List — a route list;
Param — the track paremeters settings;
Active
— a list of an active route waypoints.
To switch to the mode press the proper softkey placed on the right console. The softkey of selected mode is white
indicated.
The bottom section contains the waypoint motion control console.
10.6.3.1 RT List Mode
A list of routes with their characteristics is displayed in RT List mode.
The following characteristics are displayed for every route:
Date — creation date/time;
Route — route name;
WP
— number of waypoints.
The following actions are available in the RT List mode:
Set active — to set a route up as active one;
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
190