DPShell Service Utility
Appendix G
DPShell Service Utility
G.1
Standard Configuration (with a Touchscreen Display)
DPShell
utility description for the system configuration including a touchscreen display is specified below.
For description of the monitorless configuration see Section G.2, page 310.
G.1.1
Entering the Service Menu on DP/IJ Computer
1.1. Power up control system
NAVIS NavDP 4000
on DP/IJ computer (see Section 3.1, page 50).
1.2. Wait for
DPShell
Start Screen appearance (see Figure G.1).
Figure G.1: DPShell Main menu
This is the screen with the following menu items:
Start DP
—
NAVIS NavDP 4000
start.
DPShell
utility will start the system automatically after a delay of:
– 60 seconds — a standard delay (USB flash drive is not connected);
– 600 seconds — in case of connected USB flash drive.
The timer is displayed at the bottom of the Start Screen (see Figure G.1).
If you tap on a free area of the screen countdown will stop and
NAVIS NavDP 4000
will not start automati-
cally.
Service
— DP/IJ computer switching into “Service Mode”.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
302
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
