7
WIFI 1080P FHD
BLUE LAMP
INDICATOR
CHARGING THE BATTERY
Turn the camera off and connect the USB cable to the camera and to your power source (i.e.in-car charger, PC
USB port or USB Mains Power Adaptor) The charging indicator light will turn BLUE. When the battery charge is
full, the BLUE light will turn OFF. A typical full charge takes up to 4 hours depending on your chargers output.
WATERPROOF CASE
1.
Use your fingertip to gently pull the release clamp out and back, in the direction of the arrow (on the clamp)
2.
Inspect the white rubber water seal gasket to ensure it is in good condition, and then insert the camera in the
correct orientation.
Note 1: You can test the gasket by closing the case without the camera inside and submersing it completely in a bowl of
water for a few minutes. Remove the case from the water, dry off the exterior with a towel, and then open the
case carefully. If the interior is dry, the camera and case will be safe for use under water.
Note 2: Only two buttons are required for recording video and images: the Shutter Button, and the On/Offbutton.
Note 3: Remember, when the unit is turned OFF and ON again, the unit will default to VIDEO modes and
the default resolutions.
Power On/Off Button
Release clamp
Case Hinge
Shutter Button
OR
Wifi On/Off Button
Button
