Navien NHB-055, Руководство по обслуживанию

Страница: 29 / 147

NHB Service Manual 29 Version 1.0
c. Activate multiple zones and set the boiler to operate at
1-stage MIN mode.
Measure the CO
2
value at low fire (refer to “4.1.1 PCB DIP
Switches” on page 19 and "(3) Operation Conditions
Settings" on page 59).
If the CO
2
value is not within 0.5% of the value listed in
Table 2, the gas valve set screw will need to be adjusted.
If adjustment is necessary, locate the set screw as shown
in Figure 8. Using a 5/32 in or 4mm Allen wrench, turn the
set screw NO MORE THAN 1/4 TURN clockwise to raise or
counter clockwise to lower the CO
2
value.
Figure 10. Set Screw Location
NOTE
The set screw is located behind the screw-on cover. This must
be removed first.
d. Activate multiple zones and set the boiler to operate at
2-stage D. MAX mode (refer to "(3) Operation Conditions
Settings" on page 59). Measure the CO
2
value at high
fire.
If the CO
2
values do not match Table 2 at high fire, do not
adjust the gas valve. Check for the proper Gas Orifice.
DANGER
Improper gas valve settings can cause severe personal injury,
death or substantial property damage.
Option 2. Using Digital Manometer
a. Open the Offset pressure port by loosening the screw two
turns as shown in Figure 11.
Digital pressure
manometer
Figure 11. Connect Digital Pressure Manometer
b. Connect a manometer to the offset pressure port. For dual
port manometers, use the positive pressure side.
Model Kit Part No. Gas Type Offset
NHB-055
NAC-N1 NG -0.04 in ±0.01 in
NAC-L1 LP -0.03 in ±0.01 in
NHB-080
NAC-N2 NG -0.04 in ±0.01 in
NAC-L2 LP -0.02 in ±0.01 in
NHB-110
NAC-N3 NG -0.04 in ±0.01 in
NAC-L3 LP -0.02 in ±0.01 in
NHB-150
NAC-N4 NG -0.04 in ±0.01 in
NAC-L4 LP -0.02 in ±0.01 in
Table 3. Offset value for low fire