Navia ML8088s, Руководство по эксплуатации, Страница: 8 / 26

Evaluation Board of ML8088s Receiver
Operating Manual 2.0
8
Table 3.
Signal
Pin Jumper position for mode
Work Program
via UART0 Program
via
UART0 Reset Signal is
disabled
PPS 2 1-2 2-3
RX1 5 4-5 4-5 5-6
TX1 8 7-8 8-9 7-8* remove
GNSS status 11 10-11 11-12
Rx0 14 13-14 13-14 14-15
TX0 17 16-17 16-17 17-18
GND 20 always
connected
V_BAT 23 ** ** ** **
VCC_3.3V 26 25-26 25-26 26-27
/RST 29 28-29 28-29 29-30*** 28-29
Notes:
* - Move a jumper to pins 8-9, turn on the power (connect the USB cable) or momentarily close
contacts 29-30, then return the jumper to pins 7-8, after which start programming.
** - is supplied from outside, optional.
*** - closes momentarily.