Each time alignment setting allows the user to invert the
phase of each channel by 180 degrees. To invert the phase
of each channel, click and highlight the box to the right
of the desired channel’s time alignment setting. In the
example to the left, all channels except channel one are
180 degress out of phase.
This feature is useful in case of wiring errors where one
channel may have been wired out of phase, or in situations
were signal cancellation exists due to the individual speaker’s
location or the physical characteristics of the vehicle interior.
Each time alignment setting has it’s own phase selection
and will not automatically carry over from one time
alignment selection to the other.
Time alignment 2 is activated when the factory
Logic 7 system is on or highlighted. This allows
the user to select a time alignment set to an alternative
position in the vehicle. The set up is exactly the same as
time alignment one, just measured from a different
position in the vehicle. If no time alignement is desired,
leave each setting at zero.
*Note: If using an external DSP DO NOT use both the ZEN
time alignment setting and the time alignment
setting of the DSP. Use one or the other.
ZEN Digital Output Configuration
9