BHM
01/04/19
NTV-DOC337
3 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
RGB-LEXv2 Installation
1.
Locate the factory navigation drive. These can usually be found in the trunk, glove
compartment or under the passenger seat. Disconnect all connected harnesses before
cutting any wires.
2.
From the provided
RGB Video Harness
and refer to the chart below for your specific
vehicle RGBS pin outs. (If your vehicle is not listed, contact NAV-TV tech support at 561-
955-9770 for vehicle specific diagrams)
3.
Cut the
Red, Green, Blue and Sync wires
in
half (one at a time).
Refer to the diagram on
page 3 and make connections.
Note: RGB Ground should not be cut. Splice the ground
leads to the RGB ground (or other ground).
Note 2: While these pin locations should be
accurate, we recommend testing each wire! Refer to video if unsure:
https://www.youtube.com/watch?v=mAKbOZSv1Uo
Year(s)
Make
Model
Red Signal Green Signal Blue Signal Sync Wire RGB Ground
ALL*
ALL*
ALL*
PIN 2
PIN 7
PIN 3
PIN 8
PIN 6
1998-2000
Lexus
GS300
PIN 1
PIN 4
PIN 5
PIN 2
PIN 7
1998-2000
Lexus
GS400
PIN 8
PIN 7
PIN 6
PIN2
PIN 5
Factory connector at
Navigation drive:
*All RGB-LEXv2
compatible Toyota/Lexus
models
PIN 1
PIN 6
PIN 5
PIN 10
