BHM
11/4/13
NTV-DOC148
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Installation
1.
Begin by removing the trim which surrounds the center vents and radio with a plastic
tool, disconnect all harnesses connected to this panel and set it aside.
2.
Remove any screws securing the radio. Remove the radio from the dashboard and
disconnect any harnesses. Set the radio aside.
3.
Remove the upper media screen. This
usually requires removing (2x) Torx
screws firing up into the screen hood, or
(2x) Torx screws securing the bottom
corners of the screen.
4.
Pull the media screen from the
dashboard. Disconnect the power/CAN
harness and the LVDS cable.
5.
Connect the white, 8-pin connector on the provided
Screen T-Harness
to the
Power/CAN Connector
on the factory media screen.
a.
Connect the factory 8-pin
Power/CAN Connector
to the black connector on the
Screen T-Harness.
b.
Connect the
smaller, 8-pin
connector from
the
Screen T-
Harness
to the
provided
BMW09
Power/CAN
Harness.
LVDS Connector
Power/CAN Connector
Screen
T-Harness
Power/CAN Harness
Connect to BMW09
5. a
5.
5. b
Note: If you do not connect
the
Power/CAN
extension
(harness with filter box), the
‘R-CAM’
port will not provide
proper voltage out.
