BHM
11/4/13
NTV-DOC148
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
5 |
P a g e
11.
Connect the BMW09
Power/CAN Harness
to the interface at the port labeled
‘POWER’
.
Start the car and test for proper functionality before replacing dash pieces.
Note: If
you’re certain your connections are proper and you still get no reverse activation, see
Figure 1 (below) on this page.
12.
Note:
All other included harnesses not mentioned in this manual are not needed for most
installations.
If you would like to know more about the full capability of this interface,
contact NAV-TV tech support at 561-955-9770. Additional features not mentioned in this
manual are not supported by NAV-TV at this time.
Figure 1
If CAN data does not automatically activate reverse:
1.
Disconnect the main
POWER/CAN
connector from the BMW09 interface. Remove one of
the CAN wires with a straight pick (green or orange).
2.
Cut the removed wire from the rest of the harness.
3.
Insert the removed CAN wire into pin location 7 (picture above, right)
4.
Supply this wire with 12v when in reverse (reverse light 12v +)
5.
Adjust menu setting to activate reverse with
lamp
instead of the default
CAN
(page 4,
step 9)
6.
Reconnect
POWER/CAN
harness and test for proper functionality.
