Nautilus U10, Руководство владельца и инструкция по сборке

Страница: 15 / 60

12. Identify the lefthand and righthand mast shrouds. Position the shrouds around the mast
assembly so that the holes are aligned. Secure the shrouds to the assembly using the (3)
10-32 pan head screws. Use the #2 phillips head screwdriver to tighten.
13. (for U10 only) The seat slide assembly has two 1/4-20 set screws. Use the 1/8 allen
wrench to loosen and remove the front set screw. Insert the seat slide assembly into the seat
bracket and then re-install the set screw.
14. (for R10 only) Place the seat assembly near the seat mounting plate. Connect the harness
from the seat assembly to the harness from the frame assembly.
15. (for R10 only) Position the seat assembly against the seat mounting plate so that the holes
are aligned. Secure the seat assembly to the seat mounting plate using the (4) 1/2-13 hex head
screws and (4) 1/2 lock washers. Take care not to pinch the harnesses. Use the 3/4 hex socket
and ratchet to tighten.
16. Release the main harness (20-pin connector), ergo harness (4-pin connector) (U10 only),
both contact heart rate harnesses (5-pin connector), and the TV coaxial cable from the console
mounting plate. Pull the excess harness and cable out of the access hole.
17. Place the rear of the touchsreen
console near the mounting plate so that
the harnesses and cable can be connected.
18. Connect the main harness to the
console at JP3 as shown in Figure 2.
21. Connect the lefthand contact heart
rate harness to the console at J4 as shown
in Figure 2.
console using the supplied female-to-
female connector. Note that 7” consoles are
not TV ready and will not have a coaxial
cable connection.
23. Route the iPod cable through the access
slot in the rear of the console housing.
Figure 2
Main Harness To JP3
LH CHR Harness To J4
19. Connect the righthand contact heart
RH CHR Harness To J3
U10 Ergo Harness To J12
22. Connect the TV coaxial cable to the
rate harness to the console at J3 as shown
in Figure 2.
20. (for U10 only) Connect the ergo
harness to the console at J12 as shown in
Figure 2.
assembly questions? call 800-235-2233 for help. 15