Page 8
Required Tools:
• Metric Allen Key Set
• Loctite Blue
1
• Torque Wrench
• Metric Open-Ended Wrench Set
• Large Adjustable Crescent
Wrench
THREAD LOCKER APPLICATION:
Clean all threads and holes, apply no more than 3-4 drops per bolt.
Thru Holes
Blind Holes
PACKAGING REMOVAL:
Carefully remove all packaging materials that wrap the equipment. DO NOT USE A KNIFE OR BOX
CUTTER AS YOU MAY DAMAGE THE EQUIPMENT. At this time remove any sub-components from
the pallet and set aside for later assembly.
Once all packaging has been removed, lay all parts out in a clean open area to prepare for assembly.
Should any component not be present or if you have any operational questions, please refer to
SUPPORT &
SERVICE
1
Unless otherwise noted Loctite 242/243 or equivalent thread locker must be used on all threaded fasteners. (Do not use thread locker when a Nyloc nut
is used.)
ASSEMBLY
Metric Steel Bolts Torque Specifications
Bolt Size
Thread Pitch
Torque, N-m (lbs-ft)
6mm
1.25
10 to13.5 (8 to10)
8mm
1.25
25.5 to 28.5 (19 to 21)
10mm
1.75
55.5 to 58 (41 to 43)
12mm
1.25
61 to 65 (45 to 48)
• Torque all hardware to values as specified above, unless noted otherwise.
• See procedure of this manual for fastener sizing information; for reference only.
Note: All torque values are in N-m unless otherwise stated.
