Nautel XR12, Руководство по предварительной установке

Страница: 39 / 76

XR12 Transmitter Pre-installation Manual Control and monitoring
Issue 0.17 2005-08-31 Page 6-5
• J2-9(+) and J2-10(-): Preset Scheduler (Auto/Man).
Enables or disables the Automatic Preset (formerly power level) changes.
Provide an active pulse to toggle between Auto or Manual modes.
The associated 3-pin header/2-socket shunt post on the remote interface board is E12.
The following inputs will only take effect when the Preset Scheduler Mode is set to Manual.
• J2-11(+) and J2-12(-): PRESET 1 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E16.
• J2-13(+) and J2-14(-): PRESET 2 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E14.
• J2-15(+) and J2-16(-): PRESET 3 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E3.
• J2-17(+) and J2-18(-): PRESET 4 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E1.
• J2-19(+) and J2-20(-): PRESET 5 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E7.
• J2-21(+) and J2-22(-): PRESET 6 inputs. Selects one of six RF power presets. Provide an
active pulse to activate.
The associated 3-pin header/2-socket shunt post on the remote interface board is E5.
• TB1-13(+) and TB1-14(-): EXCITER A input terminals. Cause a changeover to select exciter
A as the main exciter. Setting is saved in current preset. Provide an active pulse to select this
exciter.
The associated 3-pin header/2-socket shunt post on the remote interface board is E4.
Note: A minimum one second interval between commands is required for the following two exciter
selection commands.