Nautel VS300, Руководство по установке

Страница: 26 / 48

VS300 Installation Manual Commissioning tasks
Page 8-4 Issue 6.0 2014-11-01
Figure 8.3: First Time Setup Completion Screen
4. When the audio setup in Step 3 is complete, the front panel should display a setup
completion screen (see Figure 8.3 ). Press the cancel (
X
) button to go back to the editing
screens. Press the checkmark button to finish the setup, which creates a new preset for the
VS300 (preset 1 or P1). The top level screen (see
Figure 8.4 ) will be displayed.
Figure 8.4: Top Level Screen
5. Enable the VS300’s RF output by pressing the cancel (
X
) button and the up arrow button
simultaneously. The RF status displayed on line 2 of the top level screen should change to RF
ON. The VS300 should be operating at the preset parameters defined for preset 1 (P1).
6. Check the four LEDs on the left-hand side of the front panel display. They should all be
green, indicating normal operation. If not, check for alarms by navigating to the front panel’s
Main Menu
->
View Status
->
View Alarms
screen. See the VS300 Operation and
Maintenance Manual for detailed information.
7. Navigate to the
Main Menu
->
System Settings
->
Calibration
->
Cal Values
screen.
Enter the screen for
Fwd Scale
(forward power scale factor) and
Rfld Scale
(reflected power
scale factor) and record the scale factor calibration value for each parameter. Store this
information in a safe place in the event that you need to replace the exciter/control PWB.
Preset 1
RF Status
Local/Remote Status
Defaulted to Local (LCL)