Nautel VS1, Руководство по установке, Страница: 30 / 54

VS1 Installation Manual Installing control and monitoring wiring
Page 7-2 Issue 2.0 2010-12-01
Figure 7.1: Control and Monitoring Connections
5. If you are using an external interlock for the transmitter, route a shielded cable to the rear of
the VS1. Connect the shielded cable between pins 19 and 20 of the D-sub connector that
mates with the
REMOTE I/O-A (A1J2A)
connector (see Figure 7.1 ). To facilitate customer
connections, Nautel provides a mating plug (Nautel Part # JS28) in the ancillary kit for the
REMOTE I/O-A (A1J2A)
D-sub connector on the rear of the VS1.
Note:
An interlock jumper (Nautel Part # 211-5060) is provided in the VS1’s ancillary kit. It is
intended to plug directly into the
REMOTE I/O-A (A1J2A)
connector on the rear of the VS1.
This jumper cannot be used if you are using a D-sub connector to make other remote I/O
connections. Instead, you must solder a jumper between pins 19 and 20 of the mating connector
(Nautel Part # JS28, also provided in the ancillary kit).
VS1 TRANSMITTER REAR VIEW
DIGITAL INPUTS AND
INTERLOCK
ANALOG AND
DIGITAL OUTPUTS
LAN (A1J8A)
(AUI web interface)