NAUMANN NM300 TRADITION, Инструкция по эксплуатации

Страница: 5 / 21

Assembling
1. Press the fasten button
，
hold the head and insert it into the inlet when
inserting please pay attention the head must be slanted as per arrow
indicated on the top, see (fig.1), then move the head anticlockwise so
that the head being fastened tightly. (fig.2)
2. Place the snake into the head,
long end
first, and turn to feed the
screw slightly until it is set into
the motor housing (fig.3).
3. Place the cutting blade onto
the snake shaft with the blade
facing the front as illustrated
(fig.4).If it is not fitted properly,
meat will not be grinded.
4. Place the desired cutting
plate next to the cutting blade,
fitting protrusions in the slot
(fig.5).
5. Support or press the center
of the cutting plate with one
finger then screw the fixing
ring tight with another hand
(fig.6). Do not over tighten.
6. Place the hopper plate on the
head and fix it into position.
7. Locate the unit on a firm
place.
8. The air passage at the bottom and the side of the motor housing
should be kept free and not blocked.
INSTRUCTION FOR USE