Assembly Instructions
Selecting the
C
orrect Battery
We do not offer batteries. However, please choose a 12 Volt rechargeable battery. Do not attempt
to recharge non- rechargeable batteries. 6 Volt battery configurations may also be used if connected
in series Negative to Positive. You may choose a Sealed Lead Acid battery, a Gel-Cell or a Deep
Cycle 12 Volt battery. Batteries come in all different sizes, Please converse with your battery dealer
for more information on which type of battery you should use for your system. Note your solar
panel amperage rating when selecting your battery size.
Electrical Installation
Please confirm that you have all parts to your system before starting installation.
Step1
Connect the battery with the SAE-battery clamp cable
Step2
Connect the SAE connector to the charge controller (the Battery side)
Step3
Connect the solar panel to the charge controller (the solar panel side)
* If your battery can not connect with the battery clamp, the included SAE-Bare end cable can be
used
When installing solar panels configuration and systems, please carefully observe correct cable
connections and polarity. The solar panels can be damaged by not observing the correct electrical
installation and polarity; in addition, this will void the warranty of your solar panels. Having a multi-
meter handy will help to confirm correct polarities.
Extending the wiring
If you choose to mount your solar panel further away from the charge controller by extending the
wiring we recommend the following gauges at each specified distance. Use stranded wire instead
of solid wire. Stranded wire does not fatigue or loose connections over time.
Appropriate wire gauge should be used for distance and total amperage, for further information
please consult with a licensed electrician or through an online wiring chart calculator
To prevent loss of current we suggest mounting the solar panel within 20 feet of the charge
controller and the charge controller should be installed within 5 feet of the battery.
Page 5 of 10
