Native Instruments Komplete Audio 6, Инструкция по эксплуатации

Страница: 46 / 58

KOMPLETE AUDIO 6 – Manual – 45
EN
GL
IS
H
3. Open the audio preferences of your audio recording software, and select the KOM-
PLETE AUDIO 6 as your input and output device (you may have to restart your host
software for the changes to become active). Refer to the documentation of your audio
recording software for information on how to configure the audio device setup.
4. Adjust the output signal of your connected device by using the relevant volume/gain
control. Check the KOMPLETE AUDIO 6’s input LEDs (INPUT 3 and 4 on the top
panel) to make sure your input signal does not clip; adjust the device’s output level so
that the LEDs light green on input. A red lighting LED indicates signal clipping.
5. Gradually turn the Volume Control knob (MAIN VOLUME 1/2) on top of the KOMPLETE
AUDIO 6 to the right until you reach a good listening level.
! %
You can also use INPUT 1 and INPUT 2 on the front panel of the KOMPLETE AUDIO 6 to
connect a line level device with a stereo output. The LINE/INST buttons adjacent to the
sockets have to be set to LINE in that case and you’d use the relevant GAIN control knobs
next to the sockets to adjust the left and right channels input gain.
7.4 KOMPLETE AUDIO 6 with MIDI Devices
7.7 KOMPLETE AUDIO 6 in a MIDI controller / synthesizer setup.
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during
the installation chapter (chapter 3), and configured as your computer’s main audio output
device (see chapter 4). See chapter 7.1 for instructions on how to connect speakers (active
and passive) to your KOMPLETE AUDIO 6. To use the KOMPLETE AUDIO 6 in a setup with
a MIDI controller:
1. Make sure to have the Volume Control knob (MAIN VOLUME 1/2) on the top panel of
the KOMPLETE AUDIO 6 turned to the left-end stop so the volume is set to minimum.