Native Instruments Komplete Audio 6, Инструкция по эксплуатации

Страница: 40 / 58

KOMPLETE AUDIO 6 – Manual – 39
EN
GL
IS
H
4. Plug the 1/4” TRS jack of your headphones into the PHONES socket on the KOMPLETE
AUDIO 6’s front panel. Turn the Volume Control knob (VOLUME) in the headphone sec-
tion of the KOMPLETE AUDIO 6 to the left-end stop to set the volume to minimum.
5. Open the audio preferences of your audio recording software, and select KOMPLETE
AUDIO 6 as your input and output device (you may have to restart your host software
for the changes to become active). Please refer to the documentation of your audio
recording software for information on how to configure the audio device setup.
6. While singing / playing an instrument into the microphone, adjust the input signal by
turning the relevant input channel’s GAIN knob gradually to the right. Check the input
LEDs (INPUT 1 and 2 on the top panel of the KOMPLETE AUDIO 6) to make sure your
input signal does not clip; adjust the input level so that the LEDs light green on input.
A red lighting LED indicates signal clipping.
7. Gradually turn the Volume Control knob (VOLUME) in the headphone section of the
KOMPLETE AUDIO 6 to the right until you reach a good listening level.
! !
For information on how to adjust the audio input for recording in your audio recording
software, please refer to your software’s documentation.