Native Instruments BATTERY 4, Руководство пользователя

Страница: 31 / 84

•
Release : Adjusts the time it takes to return to zero level after receiving a MIDI note-off
command (for instance, the MIDI trigger ends). Release control is not available in AHD mode
(see envelope mode selectors description above).
In case you selected multiple cells before activating the envelope, the most recently
selected cell (with a colored frame) will be displayed in the Waveform Control;
however, all selected cells (those with a gray frame) will be affected by the envelope
settings.
10.2. Pitch Envelope
Apply a pitch envelope to the currently active cell from here. You can see the envelope shape
against the waveform in the Waveform Control when hovering over this module.
The
Pitch Envelope module contains the following parameters and controls:
The Pitch Envelope module.
•
Power : Activates/deactivates the envelope.
•
Envelope mode : The two envelope symbols on the right side of the section header let you
choose between two types of pitch envelope: standard mode (with Amount , Decay 1 , Break ,
and Decay 2 controls), which is represented by the left envelope symbol, and easy mode (with
only an Amount , and a Decay control), which is represented by the right envelope symbol.
•
Amount : Sets the degree to which the envelope affects pitch.
•
Decay 1 : Adjusts the time for the envelope to go from its initial level (as set with the Amount
control) to the level set with the Break knob.
•
Break : Adjusts the point where the envelope breaks , for instance, the min/max value from
where it moves back towards zero (the pitch can be either higher or lower than the cell's
normal pitch).
•
Decay 2 : Adjusts how long it takes for the level set with the Break knob to decay back to zero
again.
In case you selected multiple cells before activating the envelope, the most recently
selected cell (with a red frame) will be displayed in the Waveform Control; however, all
selected cells (those with a gray frame) will be affected by the envelope settings.
10.3. Velocity
Lets you adjust how much the input velocity will affect the volume and pitch of triggered cells.
The
Velocity module contains the following parameters and controls:
MAIN PAGE 27