INSTALLATION
The installation of the convenience outlet (quick disconnect and
manual valve assembly) must be performed by the recreational vehicle
manufacturer and be in accordance with the requirements of ANSI
A119.2 /NFPA 1192 and ANSI A119.5.
The installation of the appliance mounting brackets must be
performed by the recreational vehicle manufacturer and be in
accordance with the requirements of ANSI
A119.2/NFPA 1192 and ANSI A119.5.
Installation of this grill must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code, ANSI
Z223.1 / NFPA 54, Storage and Handling of Liquefied Petroleum
Gases, ANSI / NFPA 58; or Natural Gas and Propane Installation
Code, CSA B149.1; Propane Storage and Handling, CSA B149.2; or
the Standard for Recreational Vehicles, ANSI A119.2 / NFPA 1192;
and Recreational Vehicle Code, CSA Z240 RV Series, as applicable.
This appliance shall be installed on the opposite side, from a fuel
distribution/dispensing system of an RV.
The installation of the appliance must preclude the
possibility of operation or gas flow when in storage (travel)
position.
The recreational vehicle grill (s) shall be connected to the vehicles
propane system with a flexible hose connector complying with the
high pressure requirements of the Standard for
Pigtails and Hose
Connections for LP-Gas, ANSI/UL
569, and shall be of a length no
longer than that required to allow the grill to be mounted in the "in
use" position of its mounting system.
The hose shall be installed in a manner that will not allow it to come
in contact with the hot surface of the grill while in use or in the
storage/travel mode.
To the Installer - All instructions for appliance are to be
left with the consumer for further reference.
BRACKETS
Bracket is shipped in the folded position
Unfold each arm one at a time
Arms will drop into slots.
To refold; step on bottom rail to push arms above slots.
Fold back into position.
Page 4