National Luna LEGACY Fridge Manual
18
Setting the Temperature
Minimum Temperature Settings
To select the cooling temperature, press and hold the button until the display starts to flash.
Press or to raise or lower the desired temperature. The thermostat will accept the new
setting and exit the setting mode 10 seconds after the last button was pressed. The same procedure
is used on both thermostat controls. (NOTE: You can only set one thermostat at a time).
NB - Set one thermostat at a time
National Luna
Model
Left
Compartment
Right
Compartment
50
-18
-24
60
-24
-18
72
-24
-24
90
-24
-18
110
-24
-24
Dual Control Refrigerators have two thermostats allowing
individual temperatures to be selected for each of the cooling compartments.
Operating your Dual Control Fridge
Indicator Lights
Status indicators will identify the current operation of the refrigerator.
(see main control panel on page 16)
RUN -
This indicator will be illuminated whenever the fridge Compressor is running and the
compartment is being cooled.
The Compressor is running.
½ second on, ½ second off... Compressor start up delay. There is a 1 minute delay
before the compressor starts
1 second on, 1 second off... Compressor slow down cycle.The Compressor slows
down to low speed before stopping (30 seconds)
FAULT ID -
This indicator is used to identify fault conditions that may occur with the refrigerator
such as low power supply. This indicator will flash a pre-determined number of times
every 4 seconds when a particular fault occurs (see page 20).
iiiiiii
i
iiiiii
ii
iiiiiii
i
iiiiii
ii
iiiiiii
i
iiiiii
ii
SOLID -
FLASH -
FLASH -
