National Luna LEGACY Fridge Manual
14
Setting the Temperature
The digital thermostat fitted to this
refrigerator allows accurate setting of the
desired cooling temperatures.
Temperatures can be selected between
+20°C and -30°C in 1°C increments.
When powering up the fridge the first time, the temperature inside the fridge will be reflected on
the display. (NOTE: the previously set temperature will be in memory)
To select the new cooling temperature, press and hold the button until the display starts to
flash. (The previous set temperature will be displayed).
Press or to raise or lower the desired temperature. The thermostat will accept the
new setting and exit the setting mode 10 seconds after the last button was pressed. (It will now
remember the new set temperature).
The temperature display will reflect the inner compartment temperature prior to the new setting.
Provided the new setting is colder, the compressor will then switch on and cool the fridge further
to the set point. (During this time the run indicator light will be displayed).
Operating your Single Compartment Fridge
RUN -
This indicator will be illuminated whenever the fridge Compressor is running and the
compartment is being cooled.
The Compressor is running.
½ second on, ½ second off... Compressor start up delay. There is a 1 minute delay
before the compressor starts
1 second on, 1 second off... Compressor slow down cycle.The Compressor slows
down to low speed before stopping (30 seconds)
FAULT ID -
This indicator is used to identify fault conditions that may occur with the refrigerator
such as low power supply. This indicator will flash a pre-determined number of times
every 4 seconds when a particular fault occurs (see page 20).
Indicator Lights
Status indicators will identify the
current operation of the refrigerator.
iiiiiii
i
iiiiii
ii
iiiiiii
i
iiiiii
ii
iiiiiii
i
iiiiii
ii
iiiiiii
i
iiiiii
ii
SOLID -
FLASH -
FLASH -
