TBX-1316 High-Voltage Attenuator Terminal Block
6
ni.com
Connecting the Signals
Note
Be certain that the signal wires are of the appropriate AWG and voltage for your
application, and are rated for 90 °C.
To connect a signal to the TBX-1316, perform the following steps while
referring to Figures 2 and 3:
1.
Unlock and open the enclosure door using a 3/8 in. flathead
screwdriver.
Figure 2.
Opening the TBX-1316
2.
Loosen the signal strain-relief collar.
3.
Run the signal wires through the strain-relief opening.
4.
Prepare the signal wire by stripping the insulation no more than
10 mm (0.39 in.).
Note
When connecting the signals to the TBX-1316, follow the labeling on the
TBX-1316.
