160-Pin Cable Installation Instructions
|
© National Instruments
|
31
Caution
You must install mating connectors according to local safety codes
and standards and according to the specifications provided by the connector
manufacturer. You are responsible for verifying safety compliance of third-party
connectors and their usage according to the relevant standard(s), including UL and
CSA in North America and IEC and VDE in Europe.
Refer to Table 15 for information about third-party accessories.
Compliance and Certifications
Safety
This product is designed to meet the requirements of the following electrical equipment safety
standards for measurement, control, and laboratory use:
•
IEC 61010-1, EN 61010-1
•
UL 61010-1, CSA 61010-1
Note
For EMC declarations and certifications, and additional information, refer to
CE Compliance
This product meets the essential requirements of applicable European Directives as follows:
•
2006/95/EC; Low-Voltage Directive (safety)
Online Product Certification
To obtain product certifications and the Declaration of Conformity (DoC) for this product, visit
ni.com/certification
, search by model number or product line, and click the appropriate
link in the Certification column.
Table 15.
Third-Party Accessories for the 160-Pin DIN Cable
Accessory
Manufacturer
Part Number
VARIOFACE module, with screw connection and
50 position D-Subminiature male connector
Phoenix
Contact
FLK-D50 SUB/S
Right-angle 50 position male D-SUB connector
*
Amp
747497-4
*
Small quantity orders are available from Digi-Key Corporation (part number A23398-ND).