©
National Instruments Corporation
5
SCXI-1317 Terminal Block Installation Guide
Connecting the Signals
To connect the signal to the terminal block, refer to Figures 3 and 4 while
completing the following steps.
Figure 3.
SCXI-1317 Enclosure Parts Locator Diagram
1.
Unscrew the top cover screws and remove the top cover.
2.
Loosen the strain-relief screws and remove the strain-relief bar.
3.
Prepare your signal wire by stripping the insulation no more than
7 mm (0.28 in.).
4.
Run the signal wires through the strain-relief opening. If necessary,
add insulation or padding.
5.
Insert the stripped end of the signal wires fully into the terminal.
Make sure no bare wire extends past the screw terminal. Exposed wire
increases the risk of a short circuit that can cause circuit failure.
Note
When connecting your signals to the SCXI-1317, follow the labeling on the
SCXI-1317, as shown in Figure 4. You can connect the shield of a shielded cable to GND.
1
Top Cover Screws
2
Top Cover
3
Thumbscrew
4
Connector
5
Strain-Relief Bar
6
Strain-Relief Screws
7
Safety-Ground Lug
2
7
1
4
3
5
6
