Refer to the LabVIEW FPGA Module Release and Upgrade Notes for
installation instructions and information about getting started with the
LabVIEW FPGA Module. Documentation for the LabVIEW FPGA Module is
available at
and by selecting
Start
»
All Programs
»
National
Instruments
»
LabVIEW
»
LabVIEW Manuals
.
3. Install FlexRIO Support.
Refer to the FlexRIO Readme on the FlexRIO installation media for system
requirements and installation instructions for FlexRIO Support.
Documentation for FlexRIO Support is available at
and by
selecting
Start
»
All Programs
»
National Instruments
»
NI FlexRIO
.
Installing the PXIe-7911/7912/7915
Notice
To prevent damage to the PXIe-7911/7912/7915 caused by ESD or
contamination, handle the module using the edges or the metal bracket.
1. Ensure the AC power source is connected to the chassis before installing the
module.
The AC power cord grounds the chassis and protects it from electrical damage
while you install the module.
2. Power off the chassis.
3. Inspect the slot pins on the chassis backplane for any bends or damage prior
to installation. Do not install a module if the backplane is damaged.
4. Remove the black plastic covers from all the captive screws on the module
front panel.
5. Identify a supported slot in the chassis. The following figure shows the
symbols that indicate the slot types.
© National Instruments
7
PXIe-7911/7912/7915 Getting Started
