National Instruments PXIe-5698, Руководство по началу работы

Страница: 10 / 14

1. Launch MAX.
2. In the configuration tree, expand Devices and Interfaces to see the list of installed
devices.
Installed devices appear under the name of their associated chassis.
3. Expand your Chassis tree item.
MAX lists all devices installed in the chassis. Your default device names may vary.
Note If you do not see your device listed, press <F5> to refresh the list of
installed devices. If the device is still not listed, power off the system, ensure
the device is correctly installed, and restart.
4. Record the device identifier MAX assigns to the hardware. Use this identifier when
programming the NI 5698.
5. To use the NI 5698 with the NI 5668R vector signal analyzer, you must associate the
NI 5698 with the NI 5606 RF downconverter in MAX.
Note This step is not required if you are using the NI 5698 as a stand-alone
device.
a) Select the system device with the appropriate downconverter in the configuration
tree.
b) In the Associated Devices section, use the RF Conditioning drop-down listbox to
select the NI 5698.
c) Click Save in the MAX toolbar.
Note Module associations may be lost when you move the modules to
different chassis slots.
6. Self-test the device by selecting the device in the configuration tree and clicking Self-Test
in the MAX toolbar.
The MAX self-test performs a basic verification of hardware resources.
Related Information
Refer to the NI RF Vector Signal Analyzers Help for more information about renaming
devices.
Troubleshooting
on page 10
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit
ni.com/support .
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit
ni.com/support .
Related Information
Connecting to the NI 5668R on page 6
10 | ni.com | NI PXIe-5698 Getting Started Guide