Performing a Device Self-Calibration Using the NI-RFSA SFP....................................24
Software Locations......................................................................................................... 24
Programming Examples Locations................................................................................. 27
Installation.......................................................................................................................28
Configuration.................................................................................................................. 29
Measurements................................................................................................................. 31
Where to Go Next................................................................................................................... 32
Worldwide Support and Services............................................................................................ 32
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC) stated in the product specifications. These requirements
and limits provide reasonable protection against harmful interference when the product is
operated in the intended operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may
occur in some installations, when the product is connected to a peripheral device or test object,
or if the product is used in residential or commercial areas. To minimize interference with
radio and television reception and prevent unacceptable performance degradation, install and
use this product in strict accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by National
Instruments could void your authority to operate it under your local regulatory rules.
Caution
To ensure the specified EMC performance, operate this product only with
high-quality shielded cables and accessories.
Caution
To ensure the specified EMC performance, operate this product only with
cables less than 1 meter in length.
Verifying the System Requirements
To use the PXIe-5668, your system must meet certain requirements. For more information
about minimum system requirements, recommended system, and supported application
development environments (ADEs), refer to the readme, which is installed or available at
.
Unpacking the Kit
Notice
To prevent electrostatic discharge (ESD) from damaging the device, ground
yourself using a grounding strap or by holding a grounded object, such as your
computer chassis.
2
|
ni.com
|
PXIe-5668 Getting Started Guide
