NI PXI-8104 Installation Guide
2
ni.com
Figure 1.
Removing Protective Screw Caps
Caution
Do
not
raise the injector/ejector handle as you insert the NI PXI-8104. The
module will not insert properly unless the handle is in its downward position so that it
does not interfere with the injector rail on the chassis.
6.
Hold the handle as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail.
7.
Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the NI PXI-8104
should be even with the front of the chassis.
8.
Tighten the four bracket-retaining screws on the top and bottom of the
front panel to secure the NI PXI-8104 to the chassis.
9.
Check the installation.
10. Connect the keyboard and mouse to the USB connectors. If you are
using a PS/2 keyboard and a PS/2 mouse, use USB-to-PS/2 adapters to
connect both to the USB connectors on the front panel. You may use a
Y-splitter adapter to connect both keyboard and mouse to one USB
port, leaving the other USB ports free for other peripherals, such as a
CD-ROM drive, or secondary hard drive. National Instruments offers
a Y-splitter adapter cable, part number 778713-02, available through
the online catalog at
ni.com/products
.
1
Protective Screw Cap (4X)
1
Содержание NI PXI-8104
Страница 1: ...PXI 1042...
