Mounting the Chassis on a Desktop
You can use the NI 9901 desktop mounting kit to mount the chassis on a desktop.
You must install the adapter bracket using two M3 × 20 screws. The adapter bracket
and the screws are included in the kit. Refer to the NI 9901 documentation for
information about mounting the chassis on a desktop.
Installing C Series I/O Modules in the Chassis
The following figure shows the mechanical dimensions of C Series I/O modules.
Figure 11. C Series I/O Module, Front and Side View with Dimensions
88.1 mm
(3.47 in.)
70.7 mm
(2.78 in.)
22.9 mm
(0.9 in.)
1. Make sure that no I/O-side power is connected to the I/O module. If the
system is in a nonhazardous location, the chassis power can be on when you
install I/O modules.
2. Align the I/O module with an I/O module slot in the chassis as shown in the
following figure. The module slots are labeled 1 to 4, left to right.
© National Instruments
13
NI-9146 Safety, Environmental, and Regulatory Information
