Getting Started with NI Integrated Steppers and NI 73xx Motion Controllers
|
© National Instruments
|
3
Snap-on ferrite beads for the power supply cable(s) (included with your NI UMI-7772 or
NI UMI-7774). You must use a separate ferrite bead for each power supply cable. Refer to
the
NI UMI-7772/7774 User Guide and Specifications
for installation information.
NI PS-12 or NI PS-13 power supply for the NI integrated stepper
NI ISM-7400/7401/7402 integrated stepper
Software
NI-Motion 7.6 or later driver software
Tip
Refer to KB 4WRDJ3WA,
Which LabVIEW Version Supports NI-Motion?
, at
ni.com/kb
, for NI-Motion/LabVIEW version compatibility information.
One of the following software packages and documentation:
–
LabVIEW 8.5 or later
–
LabWindows
™
/CVI
™
8.5 or later
–
Microsoft Visual C++ 6.0
–
Microsoft Visual Basic 6.0
Figure 1 shows the hardware connections using a UMI-7772/7774.
Figure 1.
UMI-7772/7774 to ISM Drive Connections
NI Motion Controller Configuration and Installation
Caution
Before installing the NI 7330/7340/7350 motion controller refer to the
user manual appropriate to your controller for safety and specification information.
Failure to follow safety instructions may result in damage to equipment.
S
HC68-C68-
S
C
a
ble
NI P
S
-12/1
3
Power
Su
pply
NI I
S
M-7400/7401/7402
Integr
a
ted
S
tepper
(I
S
M-7400
S
hown)
L
N
-V
+V
Made in China
+V ADJ
+
OUTPUT: 48V 6.7A
INPUT: 100-240VAC 5A 50/60Hz
L
N
-V
+V
M
a
de in Chin
a
+V ADJ
+
.
Encoder
Connection
s
+24 V Power
Su
pply
(NI P
S
-15
S
hown)
UMI-7772/7774
I/O Connection
s
