34
|
ni.com
|
NI 5782R User Manual and Specifications
with which NI complies, as well as other environmental information not included in this
document.
Waste Electrical and Electronic Equipment (WEEE)
EU Customers
At the end of the product life cycle, all products
must
be sent to a
WEEE recycling center. For more information about WEEE recycling centers,
National Instruments WEEE initiatives, and compliance with WEEE Directive
2002/96/EC on Waste and Electronic Equipment, visit
ni.com/environment/
weee
.
Appendix B: Installing EMI Controls
To ensure specified EMC performance, an HDMI cable ferrite and PXI EMC filler panels must
be properly installed in your NI FlexRIO system. Your kit includes the HDMI cable ferrite, but
the PXI EMC filler panels (National Instruments part number 778700-01) must be purchased
separately. For more installation information, refer to the
NI FlexRIO FPGA Module Installation
Guide and Specifications
.
Installing PXI EMC Filler Panels
Complete the following instructions to install PXI EMC filler panels (National Instruments part
number 778700-01) in your PXI chassis:
1.
Remove the captive screw covers.
2.
Install the PXI EMC filler panels by securing the captive mounting screws to the chassis,
as shown in the figure below. Make sure that the EMC gasket is on the right side of the
PXI EMC filler panel.
⬉ᄤֵᙃѻક∵ᶧࠊㅵ⧚ࡲ⊩ ˄Ё
RoHS
˅
Ёᅶ᠋
National Instruments
ヺড়Ё⬉ᄤֵᙃѻકЁ䰤ࠊՓ⫼ᶤѯ᳝ᆇ⠽䋼ᣛҸ
(RoHS)
DŽ݇Ѣ
National Instruments
Ё
RoHS
ড়㾘ᗻֵᙃˈ䇋ⱏᔩ
ni.com/
environment/rohs_china
DŽ
(For information about China RoHS compliance,
go to
ni.com/environment/rohs_china
.)