National Flooring Equipment HELIX, Руководство по обслуживанию, Страница: 9 / 32

Troubleshooting Guide
9
Problem Solution
Machine is hard to handle Change to a less aggressive tooling.
Remove weights.
Change handle position to gain better leverage.
Debris is coming out from the bottom of the
machine
Check dust skirt to make sure it is mounted and secured properly. The bottom edge of the
skirt should be touching the floor.
Remove vacuum hose and check to see if port is plugged.
Ensure dust collector is working properly.
Blows fuses or circuit breakers Ensure use of proper extension cord. See Safety section.
Move to a different outlet on an independent circuit.
Change to a less aggressive tooling.
Remove weights.
Motor will not run Ensure machine is connected to power.
Check if light on motor is on; if so, change brushes.
Ensure safety key is properly inserted.
Ensure handle and motor cords are connected.
Noisy or excessive vibration Change to a different tooling specific for the job.
Ensure tooling is properly installed.
Light does not turn on Ensure light is plugged in (just above where the light is located).
Satellites do not rotate freely Clean satellite bearing bores and satellite shafts.
Note: For further assistance, contact NFE customer service.