Maintenance
19
MANUAL SLIDE PLATE REMOVAL
1.
Disconnect machine from power.
2.
Remove slide plate pin.
3.
Remove cutting head bolt
4.
Remove cylinder from slide plate.
5.
Remove slide plate.
OR
1. Disconnect machine from power.
2. Disconnect hydraulic lines from cylinder. A small amount of oil leak out of lines, place rag below line to catch fluid. Cap lines or bleed into
a container. Wipe up spillage immediately.
3. With lines removed, loosen slide plate bolts. Hold slide plate at the top of the cylinder.
4. Remove slide plate, cylinder and lower cutting head support.
LEAK MAINTENANCE
All fittings on this machine are O-ring style.
1.
Disconnect machine from power.
2.
If a leak is detected, tighten fitting with the proper wrench size. Do not over-tighten. Over-tightening could damage to O-rings.
CHECK HYDRAULIC OIL LEVEL
Check fluid level in the fill hole on the right side of the frame, in front of the rear wheel.
1.
Remove filler plug.
2.
Oil should be visible 1” below hole.
3.
Reinsert plug.
HYDRAULIC OIL CHANGE OUT
1. Disconnect machine from power (charger or battery).
2. Drain fluid by removing the drain plug from side of tank. This unit contains 6 gallons (22.7 liters) of fluid. Ensure the container size is ad-
equate to catch fluid.
3. Replace drain plug.
4. Remove filler plug.
5. Add oil into the fill hole. Total tank capacity is 6 gallons (22.7 liters). Due to a certain amount of retained oil, the oil change refill amount is
5.5 gallons (20.8 liters).
NOTE: Adding more than this amount could cause the oil to overflow from the vent tube.
WARNING:
ALWAYS DISCONNECT BATTERY BEFORE PERFORMING MAINTENANCE.
WARNING:
SLIDE PLATE WILL DROP TO THE FLOOR WHEN SLIDE PLATE SECURING BOLTS ARE DISENGAGED. KEEP HANDS
AND FEET OUT FROM UNDERNEATH SLIDE PLATE, FAILURE TO DO SO COULD CAUSE SEVERE BODILY INJURY.
402228_5200QL_RevE
To
order
go
to
Discount-Equipment.com
