![background image](http://html1.mh-extra.com/html/national-flooring-equipment/14420/14420_instruction-manual_3369241018.webp)
Maintenance
end of the shaft on the top of the machine with a 3/4” wrench and turning the pad holder counterclockwise. (Models equipped with dust
collection will require removing the pulley cover to gain access to the belt.)
2. Use the 3/4” wrench to turn the end of the spindle shaft on top of the machine while removing the old belt from the spindle pulley.
3. Finish removing the belt from the engine pulley, if necessary.
4. Check engine pulley for correct alignment with the spindle pulley. Check hardware attaching pulleys for proper tightness.
5. Install the new belt onto the engine pulley.
6. Re-install the new belt onto the spindle pulley using the 3/4” wrench to turn the spindle clockwise. Make sure the belt is correctly placed
on the idler pulley.
7. Re-install the pad holder onto the spindle shaft.
8. Turn the machine upright in the burnishing position.
9. Check belt for correct operation. Check all hardware for proper tightness.
BATTERIES
The battery supplied with this machine is a sealed, absorbed glass mat (AGM), maintenance-free type. It never needs servicing. When battery
replacement is necessary:
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3.
Disconnect the BLACK negative battery cable first. Disconnect the RED positive battery cable last.
4. Loosen battery-retaining strap.
5. Lift out old battery and replace with new battery.
6. Secure battery with battery-retaining strap.
7.
Connect the RED positive battery cable first. Connect the BLACK negative battery cable last.
Dispose of old battery in the proper manner. Most auto parts stores accept used batteries for recycling.
18