Machine Preparation
11
FIG. 4
FUSES
The machine’s electrical circuit is protected by a fuse, which stops the flow of current in
the event of a circuit overload. Once a fuse blows, it must be replaced. If the overload
that caused the fuse to fail is still present, the new fuse will fail and the problem must be
corrected. Do not bypass any fuse. The ignition fuse is located on the side of the starter
switch panel.
WHEEL ADJUSTMENT
1. Close the valve on the propane cylinder; allow the engine to stop and turn the
machine OFF.
2. Remove the propane cylinder.
3. Place machine in the Rok-Bak position.
4. Remove the clevis pin that retains each wheel and relocate to the desired wheel
position (Figure 4).
Note: To increase pad pressure (more aggressive) move wheels to rear of machine. To
decrease pad pressure (less aggressive) move wheels toward the front of machine.
DUST BAG - OPTIONAL
1. Pull up on rear of dust bag to detach Velcro from the support tab.
2. Pull dust bag downward off dust tube by holding at the front and pulling down and
to the rear to remove.
3. Empty bag by rubbing or gently tapping on sides, in a downward motion, to loosen
soil trapped on sides of bag. For heavy soil, turn bag inside out to clean.
4.
Reinstall bag by hooking elastic edge onto back of dust tube lip, and fitting elastic
around dust tube.
5. Pull rear of dust bag towards rear of machine and reattach to Velcro on the support
tab.