WINDSHIELD INSTALLATION
ATTACH UPPER AND LOWER SHIELDS TOGETHER
1. Make six assemblies using, Panhead Machine Screw
(12), Flat Zinc Washer (13), Rubber Washer (14) and
Windshield Spacer (15).
Illustration A
2. Insert the assembled components into each of the
mounting holes where the lower edge of the Windshield
Upper Section meets the top edge of the Windshield
Lower Section. Make sure the Windshield Spacers do
not come loose and fall out.
Illustration A
3. From the bottom of the two edges, assemble a Rub-
ber Washer (14), Flat Zinc Washer (13), and Nylon Insert
Nut (16), and tighten the Nuts finger-tight for now.
Figure 17
The Spacers (15) should fit through the Rubber
Washers (14) and up against the Metal Washers
(13).
4. Made sure the Upper and Lower Windshields are
flush with each other and the side edges are in line.
5. Tighten the Screws (12) and Nuts (16) securely.
(Phillips Screwdriver and 7/16” Wrench)
13
12
15
16
14
14
13
Illustration A
Figure 17
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 8 of 12
10-118032-000 05/15
