WINDSHIELD INSTALLATION, continued
6. Remove the adhesive backing from the Velcro loop
material and then press the windshield tab firmly onto
the hood of the vehicle.
Figure 22
7. Check that the Wire Harness is coiled and secured.
FINALIZE CONNECTIONS TO WIPER
1. Check that the Wiper Arm Fluid Hose is threaded
through the Grommet in windshield. If it is not, do this
now.
Figure 23
2. Connect the Wiper Motor Power and Fluid Hose.
Figure 24
A little moisture on the Fluid Hose end will make
them join easier.
3. The arrow on the fluid check valve must point towards
the wiper arm, not towards the fluid reservoir.
Figure 24 Inset
4. Tuck Motor Connector behind Motor assembly.
5. Completed Windshield Wiper Motor installation should
appear as shown in Figure 24.
FILL THE FLUID RESERVOIR
1. Fill the Reservoir (10) inside the vehicle’s cab with
plain water during warm weather and glycol-based auto-
motive windshield washer fluid in freezing weather.
2. DO NOT run the pump dry. Minimum amount of fluid
to maintain in the Reservoir is:
12 oz. (.35L) or to a depth of 1 1/2” (38mm)
REINSTALL PARTS REMOVED FROM VEHICLE
1. Reinstall the seats.
2. Reinstall the center console.
Figure 22
Figure 23
Figure 24
Minimum depth of 1 1/2”
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 10 of 12
10-118032-000 05/15
Please refer to page 11 and 12 for operation,
replacement parts and warranty.
Enjoy Your New Wash’n’Wipe™ Windshield!
