WIRE HARNESS INSTALLATION-
BATTERY TERMINUS
To prevent ends from snagging while routing
terminus (a), tape the positive and negative
connectors together.
1. Route the Battery terminus end (a) toward the console
tunnel following the vehicles main wiring harness.
Figure 13
2. Continue to pull the Battery terminus section of the
Wire Harness along the vehicle’s main wiring harness to
the battery compartment.
Figure 14 and 15
3. Loosen the negative terminal nut of the vehicle’s bat-
tery. with a Philips screwdriver or an adjustable wrench.
Slip the Brass Open Ring Connector under the negative
terminal nut and tighten securely. Repeat for the positive
terminal.
Figure 16 (Phillips Screwdriver)
SECURE WIRE HARNESS THROUGHOUT VEHICLE
Use the Zip-Ties (21) to coil and secure the Wire Har-
ness properly within the vehicle.
Do not leave loose Harness anywhere in the vehicle.
Once Zip-Tie is tight, clip excess off end.
(Wire Cutters)
SECURE a minimum of three locations inside
front compartment.
Figure 6, page 5
SECURE at three locations to vehicle’s wire
group along center floor of vehicle. Stay away
from the drive shaft.
Figure 15
SECURE excess inside battery compartment.
Figure 16
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 7 of 12
10-118032-000 05/15
Figure 14
Figure 13
Figure 15
Figure 16
