15
After placing the weight, close the hood and spin the wheel. The machine will beep and
you will see the following screen for a short time:
After showing this screen, the machine will automatically return to the initial balancing
screen. You have successfully calibrated the machine and the data was saved
automatically.
Please note that if you do not put a wheel weight on the rim, the machine will not
calibrate. You will cause the machine to “chase itself to infinity” when trying to
calculate the calibration. The resulting screen will look like this:
If you see this screen, you did not calibrate it correctly. Turn off the machine and try
again.
8. Standard Dynamic Mode
After completing the steps above, you are now ready to balance. Standard Dynamic
mode is for balancing steel wheels by placing clip on weights on both the inside and
outside of the rim. It is not for using aluminum wheels or stick on weights.
This is an example of balancing a steel wheel:
Start by placing the wheel on the machine and entering the parameters. Close the hood
and spin the wheel. You will see:
Use your hand to rotate the tire until all 5 of the lights in the
OUTSIDE UNBALANCE
POINT
are on, as shown here:
Содержание NTB-800
Страница 7: ...7 6 Wheel Parameters Input Install the wheel in either of the two ways shown here...
Страница 8: ...8...
