13
This must be performed before calibration and before balancing any wheel. If all four
wheels for one vehicle are the same and being balanced, then parameters only need to be
input one time. If you turn off the machine, the wheel parameters are forgotten and must
be entered again.
7. Calibration
Calibration must be performed before machine will balance a wheel. If you move your
balancer, calibration must be performed again. If you unplug or lose power to your
balancer, calibration must be performed again. You do not have to leave the balancer
power on, but do not unplug it from the electricity. Please remember to use a power
surge protector to prevent damage to the electronics.
To begin, you must have a 15 or 14 inch steel rim with tire. If you don’t use a 15 or 14
inch steel rim, the machine will not balance correctly. Install this on the machine.
First, enter the wheel parameters then return to the initial balancing screen.
To enter the calibration process, do the following:
Push and hold down the
FINE
button. While holding down the
FINE
button, push and
hold down the
ENTER
button. With both buttons being pushed, release the
FINE
button. The following screen should appear:
Now push and hold the
ENTER
button. While pushing and holding the
ENTER
button,
push and hold the
FINE
button. The following screen will appear:
Now press and release the
ENTER
button one time. The following screen will appear:
Содержание NTB-800
Страница 7: ...7 6 Wheel Parameters Input Install the wheel in either of the two ways shown here...
Страница 8: ...8...
