10
Motor output
U, V, W, P.E.
It is recommended to use pre-insulated female faston terminals 6,3x0,8 mm.
In case the device is mounted on motor terminal box, it is suggested to use PVC wires 200 mm long with cross section 1.5
mm2.
In case the device is mounted on the wall, it is recommended using schielded cables of proper cross section depending on
cable length and motor power. The screen has to be connected to both side.
Follow the below figure for correct cable stripping.
Analog inputs (sensors)
AN1: 4-20 mA, sensor 1
AN2: 4-20 mA, sensor 2
AN3: 0-10 V, external set
AN4: 0-10 V, trimmer for frequency regulation or external set 2
+10
+15
It is recommended to use pre-insulated ferrules.
Use shielded signal cables by placing the screen at one end using the provided EMC clips.
Follow the below figures for correct cable stripping and EMC clip assembling.
