erly positioned in the axle support cups, and that the right side axle support cup is
securely tightened.
12. Tighten the knob bolt (C) until the drive roller contacts the rear tire. Then, turn the
knob bolt an additional 3 complete rotations. If the tire slips on the roller, turn the
knob bolt by additional
1
/
2
turns as necessary to eliminate any slippage.
13. Install the included “AA” batteries in the computer console (E). Remove the battery
cover from the underside of the console, install the batteries according to the orienta-
tion diagram inside the battery compartment, and replace the cover.
14. Attach the resistance shift lever (D) and computer console (E) to the handlebar,
preferably close to the stem. Use care to mount the shift lever so that the cable does
not interfere with the operation of the bike or the resistance unit. It may be necessary
to remove one or both of the rubber shims (K) from the shift lever bracket in order to
fit larger diameter handlebars. For smoother shifting, avoid kinks or sharp bends in
the cable.
15. Connect the computer console cable and the resistance unit data cable to the shift
lever body. See Figure 5A and 5B.
Tip:
To make your indoor workout as quiet as possible, set the trainer on a small
section of carpet, and use a rear tire with a smooth tread pattern.
V. Setup
Data generated by the Watt Master computer will be accurate only if you first perform the
following simple set-up procedure. The set-up screens cannot be accessed while the
trainer is in use.
Note:
In order to provide accurate data, the weight setting (rider bicycle
weight) must be programmed for each user. When switching riders, be sure to program
the weight setting (see below).
1. To enter the set-up screens, press and hold the right (MODE) button for 4 seconds. See
Figure 6.
2. Select metric or imperial units of measure. Press the left (SET) button to select
between KM/H, Meters and Kilos, or M/H, Feet and Pounds (Lb). See Figure 7.
Press the MODE button to enter your selection and proceed to the Weight set-up
screen.
3. The weight value will appear on the top line of the display screen, with the right digit
flashing. See Figure 8.
Note:
This value represents the combined weight of the rider
and the bicycle. Enter the combined weight of the rider and bicycle by pressing the
SET button to adjust the flashing digit. Press the MODE button to enter your setting
and proceed to the next digit. Repeat this process to set the remaining digits. When
finished, press the MODE button to enter the value and proceed to the Type set-up
screen.
4. The correct Type setting for the Watt Master Mag is Type 1. See Figure 9. Press the
SET button until “type 1” is displayed. Press the MODE button to enter your
selection and exit the set-up screens.
VI. Using Your Watt Master Mag Trainer
Once the bicycle is mounted to the trainer (see section IV), and the initial set-up is com-
plete (see section V), you are ready to ride.
4
6
Mode
5A
Make sure that resistance unit cables are clear of all moving bicycles parts.
5B
Set
K
Failure to securely attach the bicycle to the trainer could result in serious injury.
4
G
I
H
I
3
UNLOCKED
LOCKED
G
H
I
▲
!
WARNING
▲
!
CAUTION
