4. USING THE HEATER
BEFORE PLUGGING IN THE HEATER,
INSPECT THE SAUNA ROOM!
- The heater’s control switch is located in the
front at the lower part of the heater.
4.1 Overview
- The heater is switched on and off by toggling
the I/O button.
- The SET button is used for setting the following
parameters: Preset timing, power-on time and
temperature.
- The setting is carried out using the +/- buttons.
During set-up, an LED flashes to indicate the
parameter being set, with the respective value
being displayed on the screen.
- The settings of the power-on time and the temperature
remain in memory even after a short outage of power.
After a longer outage of power, the times are reset to their default values.
The preset timing will always be reset after use.
- The On/Off LED is illuminated red whenever the heating elements are turned on; at all other
times it is illuminated green. During the preset time, the On/Off LED is not illuminated.
Figure 5.
On/Off signal light
Preset timing (yellow)
Power-on
time (green)
Temp. (red)
SET
3.2 Installing the heater and piling the stones
- The heater can be placed on the floor.
- When installing the heater, observe the given safe
distances.
- The heater must be attached to the wall or to the
benches using two support irons, as illustrated in Fig. 3.
- The protective film of the heaters casing and the
cardboard support of the resistors need to be removed
before using the product.
- Pile the stones carefully, using safety gloves.
- Pile the stones carefully so as not to damage the
exterior coating of the heater. Select flat stones for the
space between the resistors.
- When piling the stones, make sure that the resistors do
not get bent and that the circulation of air is sufficient.
- Use proper sauna stones (for example olivine diabase)
with the diameter of 5-10cm.
- Pile the stones loosely. Stones that are piled too tightly
may make the resistors overheat (= shorter life span)
and slow down the heating of the sauna.
- The stones must cover the heating resistors completely.
- Do not pile the stones above the top of the heater.
See figure 4.
- The heater stones should be inspected and repositioned
every 6 months and the stones should be replaced
every 2-3 years
- Soap stone- or ceramic stones are not suitable for
this heater.
DO NOT USE THE SAUNA HEATER WITHOUT STONES.
A STONE CONTAINER THAT IS FILLED TOO
SPARSELY MAY BE A FIRE HAZARD!
Figure 4.
Figure 3.
min 50
min 50
max 400
min 30
min 300
max 900
min 600
100
min 50
min 50
min 50
min 50
max 400
min 30
min 300
max 900
min 600
100
min 50
min 50
