NARVI Softy 4,5kW, Инструкция по установке и эксплуатации

Страница: 13 / 64

INSTALLATION AND OPERATING
INSTRUCTIONS
NARVI SOFTY 4,5kW 907112
NARVI SOFTY 6kW 907113
NARVI SOFTY 9kW 907115
GB
1. THE ELECTRIC STOVE SET INCLUDES:
1. stove with control unit
2. fastening plates and fastening screws
3. sensor
4. control console
5. installation and operating instructions
2. BEFORE INSTALLATION:
Check on the following:
– Make sure the stove capacity (kW) corresponds to the size of the steam room (m
3
).
– Table 1 shows the stove types that correspond to various size saunas.
– If the steam room has any non-insulated brick, tile or glass surfaces, 1.5 m
3
of
space must be added to the size of the steam room for every square-meter of such
surfaces. Based on the result, choose the stove with the required capacity shown
in table 1.
When choosing a stove, strictly adhere to the steam room space shown in table 1.
Table 1. Installation information for SOFTY stoves
– The minimum height of the steam room and minimal safety clearances are
shown in table 1.
– Make sure that the surface onto which the fastening plates are being screwed is
sufficiently strong. Thin boarding is not sufficient. The surface can be reinforced with
a supporting framework under the boarding or reinforcing boards on top of the wall,
which is connected to a wall framework.
– The stove can also be installed into a wall recess, see figure 1.
ONLY ONE ELECTRIC STOVE MAY BE INSTALLED IN EACH SAUNA ROOM.
Stove model Capacity Sauna room Minimal safety clearances for the stove Quantity
of stones
Connection *)
Volume Height on the sides at the front to the ceiling to the floor 400 V 3N Fuses
min max min A **) B **) C **) D **)
kW m
3
m
3
cm cm cm cm cm kg mm
2
A
SOFTY 907112 4,5 4 6 190 20 20 70 3 60 5x1,5 3x10
SOFTY 907113 6 5 8 190 20 20 70 3 120 5x1,5 3x10
SOFTY 907115 9 8 14 190 20 20 70 3 120 5x2,5 3x16
**) See figure 1 *) Connected with rubber cable, type H07RN-F
or corresponding cable