NARGESA PC16, Инструкция

Страница: 17 / 37

INSTRUCTIONS BOOK FOR HOT WROUGHT IRON MACHINE PC16 16
6. POSSIBLE FAULTS
6.1 Electrical faults
Due to the daily use of the forging machine PC16 NARGESA, anomalous situations may arise which we
try to describe below in order to facilitate the use and repair in any case
NOTE: In case of repeated anomalies please contact technical support NARGESA.
Fault Cause Solution
The control panel
does not light up
No power supply
Make sure the machine is properly
connected to power supply
Some phase power is faulty
Make sure we get the three phase
tension
Maneuver Thermal protection is disa-
bled
Reset the circuit breaker of the
maneuver
Protection fuse is blown Replace the fuse
El Motor eléctrico no
se pone en marcha
Thermal motor protection
is disabled
Reset motor protection
One power phase is faulty
Make sure that we get the three
phase tension
Emergency stop is activated
Disengage the emergency stop and
reset the machine
Failure of the motor contact. Contact our technical assistance