NARGESA CC60, Инструкция

Страница: 43 / 63

- 42 -
NON - MANDREL TUBE AND PIPE BENDER CC60
7. TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Internal wrinkle The pipe moved out of the clamp Make sure the clamp is in good
conditions
Internal wrinkle Counter - die with low pressure Tighten the counter - die
Internal wrinkle Lack of lubrication Use BEND8 or another similar
Internal wrinkle The diameter of the die is too small for
the pipe thickness Increase the pipe thickness a little or
buy a die with a diameter of more than
3 times the pipe diameter
Internal wrinkle Worn counter - die Buy a new counter - die
Excessive final
deformation on the Counter - die with too much pressure Loosen the counter - die
Flattening on the
outside of the bend Counter - die with too much pressure Loosen the counter - die
Flattening on the
outside of the bend Pipe not thick enough Increase the pipe wall
The machine can ’ t
bend
The material hardness is much higher
than recommended by the Contact the pipe manufacturer
The machine can ’ t Lack of lubrication Use BEND8 to reduce friction