Spectrum View
69
Setting the measurement time (Meas. Time)
Here you can set the measurement time. The measurement or detector time defines the time
range used by the internal detectors to calculate their values (
+Pk
,
RMS
,
-Pk
, ...).
To set the measurement time:
You selected the desired view.
1.
Tap the
Meas. Time
button.
2.
Enter the required value and select a unit.
The setting is accepted immediately and the dropdown list is closed.
Configuring the measurement performance
(Config)
Here you can define how measurements are performed.
To open the Config menu:
You selected the desired view.
1.
Tap the
Config
button.
2.
Then you can do the following:
Setting the number of measurements (Scan. No)
Sets the number of measurements for a single run measurement until the measurement
stops.
It also affects the longtime detectors (
MxP
,
MxR
, ...).
To change the parameters:
1.
Tap the button and set the number of measurements either by using the rotary control
knob or by entering the value.
2.
Tap the
OK
button.
3.
Press the
Esc
key or tap the header to close the menu.
Setting the measurement sequence (Seq Mode)
Here you can set the following:
•
Single
: Measurement stops after the number of scan count is reached.
•
Conti
: Continuous measurement.
To change the parameters:
1.
Tap the toggle button to select
Single
or
Conti
.
2.
Press the
Esc
key or tap the header to close the menu.