NARDA PMM CA0010, Руководство пользователя, Страница: 42 / 74

3-18 Setup and Panel Instructions
3.9 Test Set up As required by the relevant standards, the discontinuous measurement
(Click) test set up shall be the same adopted for continuous disturbances,
therefore, usually, a LISN is used to sample the RF signal to be measured.
Both in case the rate N is to be evaluated from the RF signal measurements
and from the switching operations counting, it needs only the connections
between the PMM CA0010 Click Analyzer and the PMM 9010F Emi
Receiver, since the internal LISN is properly routed automatically.
The EUT Power Connector will be used to feed the EUT through the
CA0010 internal 16 A LISN, and the hardware connections scheme will
become then:
Fig. 3-8 Test Set up
For the system to work properly, another connection only is required.
Please connect the rear RS232 port of the PMM 9010F to the one of the
PMM CA0010, using the provided DB9-male to DB9-male short cable.